Ferrari electronic OfficeMaster Gate, User Manual

Page: 47 / 108

41 www.ferrari-electronic.de
Configuration
Usually, the Lync-Mediation Server will use the port 5068 for incoming TCP connections and the port 5067 for
incoming TLS connections. Those ports are therefore to be set up in the rules of the gateway for incoming calls. For
the other way, so towards the gateway, there are two possible ways:
• Use of the SIP standard port (5060 for TCP and 5061 for TLS)
• Use of the suggestions of the Topology Builder (5066 for TCP and 5067 for TLS)
Whatever was is chosen, it is important that in any given case, the settings of the Topology Builder and those of
the VoIP parameter in the gateway are consistent with each other.
This will have laid out the gateway, but the assignment to a Mediation Pool is still missing. This is why the
Topology Builder will still show an icon at the top left side, indication that the configuration is yet to be complet -
ed. A click on Lync Server 2010 (top) will show applicable details under „Topology validation errors“ in the main
window:
Image 3.30: Topology builder error message
Under „Mediation pools“ the preferred server is selected and editing activated by pressing „Edit Properties...“.
There, the gateway is selected and added to the server.
Image 3.31: Mediation Pools
The ports that the Mediation Server will accept incoming connections are also selected here. These, contrary to
common belief, do not have to be identical to the ports at the gateway side. Important is solely, that the respective
side addresses the right ports of the other side. The Lync side was just configured when the gateway was set up, the
gateway side will be explained further down where the advanced gateway configuration mode is explained. In the
simple mode, that the ports shown are automatically used as targets.
After every change in settings, the Topology has to be published by pressing
„Publish...“
Afterwards, in the
Lync Control Panel under
„Topology“
it can be checked whether or not the changes have been replicated by every
server.
Dial Plan
Another important part of telephony is an appropriate Dial Plan. Dial Plans can very easily be set up and config -
ured via the „Lync Server Control Panel“. A standard Dial Plan called „Global“ exists from the start and cannot be
deleted either. Has nothing contrary been configured, this is true for every user.