OBID i-scan
®
System-Manual
ID ISC.MR200
FEIG ELECTRONIC GmbH
Page 31 of 144
H40801-5e-ID-B.doc
IN-ACTIVE:
Determines if the input is active with a closed or open contact:
Bit:
7
6
5
4
3
2
1
0
Function
0
0
0
0
0
0
IN2
IN1
Bit = 0
⇒
closed contact activates input
Bit = 1
⇒
open contact activates input
REL-TIME:
Defines the relay holding time. If the Reader receives a valid Transponder response the relay
is activated for the value in REL-TIME.
If REL-TIME is zero the function is disabled.
If relay is on in idle mode, the relay will be deactivated for REL-TIME.
If the flash mode is enable, the relay will activated.
Range: 0x00 ... 0xFFFF ( * 100ms) = 0s ... 6553,5s.
OUT2-TIME:
Defines the holding time of the digital output OUT2. If the Reader receives a valid Trans-
ponder response the Output2 is activated for the value in OUT2-TIME.
If OUT2-TIME is zero the function is disabled.
If OUT2 is high in idle mode, OUT2 will low for OUT2-TIME.
If the flash mode is enabled, the output goes low.
Range: 0x00 ... 0xFFFF ( * 100ms) = 0s ... 6553,5s.
•
Note:
If the REL-TIME and / or OUT2-TIME is > 0x00 the relay and / or OUT2 will be active if the
communication (Inventory) between the reader and the transponder was OK.