- 41 -
1.
Disconnect power to display case.
2.
Remove all interior shelving as described in the shelving installation and removal section of this
manual.
3.
Remove both shelf standards from interior of case by removing thumb screws located at top and
bottom of shelf standard.
4.
Remove end glass as described in end panel removal section of this manual.
(Step 5 & 6 Refrigerated Models Only)
5.
Lift the Display Deck(s) up and out of evaporator tub and remove from case.
6.
Remove the evaporator fan shroud by removing the thumbscrews along the backside of evaporator
fan shroud and the (2) thumb screws on each side of evaporator coil. Unplug fan(s) from wire
harness and remove evaporator fan shroud with fan attached from case.
7.
Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a damp
cloth and allow to dry.
8.
Clean all shelves, shelf support bars, shelf standards, shelf brackets, and display deck using warm
soapy water and a brush. Rinse thoroughly and allow to dry.
9.
Clean behind front glass hing using warm soapy water and sweeping debris to each end and
10.
Clean all foreign material from inner and outer rear door tracks using warm soapy water and a
brush. Apply a light film of lubricant such as PAM to make the doors operate smoother.
11.
Clean both sides of the doors, end glass and front glass using any common window cleaner.
NOTE: Front glass can be tilted forward to simplify front glass cleaning. To allow easier access to
clean interior tilt the front glass forward. Tilt the front glass out by grabbing the top edge of glass
with finger tips and pulling it away from magnetic strips on case. Tilt glass until it stops at about 30
degrees angle. IMPORTANT: Hold on to the glass until it stops and do not let it free fall. Allowing
glass may damage glass or hinge. The glass can then be cleaned with common window cleaners.
Close the glass by pushing glass back up agaist magnetic gasket in closed position.
12.
Reassemble the case in reverse order.
Weekly Exterior Cleaning
1.
Clean the front, end glass and rear doors using any common window cleaner.
2.
The exterior surfaces should be wiped down using any ammoniated cleansers or warm soapy water.
