- 25 -
Counter Models
Panels must be in place when operating the case.
PANEL
PANEL SCREWS
PANEL CENTER
ATTACHMENT
POINTS.
PANEL BOTTOM SLOTS
PANEL
SCREWS
PANEL TOP SLOTS
PANEL
On counter drop in models, the panels are split to allow panel to easily be removed out of swinging cabinet
doors that may have a center post.
Also note that unit is shipped with louvered panels on back of case and solid panels on front. This allows
air flow for condenser to be in and out of the back of cabinet. These louvered panels can be switched with
solid front panels to allow air flow in and out front of cabinet. They can also be mixed with one louver
panel in front and one in back to allow front condenser air in or out of front and rear air in or out back. This
must be determined before placing unit into counter and cabinet must be prepped to allow desired air flow
See cabinet prep section of this manual. When removing and installing panels be sure panels are reinstalled
in correct location to allow condenser air flow.
Note: The front and back panels instruction are identical.
1.
Disconnect power to Display Case.
2.
Open cabinet door to allow access to condenser compartment.
3.
Remove (2) panel screws in outside upper and lower corners of panel.
4.
Slide slotted end of panel out of center attachment point and remove from case. Note: Do not
remove screws from center attachment point.
DANGER: Electric shock hazard. Do not operate unit with panels removed.
