VAIE 2000 | Voice Alarm Integrated Systems
System Manual | 2013
UK
10
VAC 2006 • VAR 2006
8.6 < ConFIGuRAtIon > MEnu
Panel for selecting options pertaining to personnel specifically
trained and authorised to use the advanced system functions
and to modify the configuration parameters for starting and
maintaining the system.
A password for accessing these functions may be added.
The options of the
ConFIGuRAtIon
Menu enable the following management panels to be accessed:
8.6.1
ACQuIRE IMPEdAnCE
panel (via the
acquire > IMPEdAnCE
option)
For acquiring and storing the impedance values of the speaker unit lines, which is necessary for system initialisation and diagnostics.
8.6.2
SEt toLERAnCE
panel (via the
set > IMP. toLERAnCE
option)
For setting the tolerance applicable to the line impedance. When the diagnostic system detects impedance that is out of tolerance, a “Fault
Warning Condition” is activated.
8.6.3
20KHZ LEVEL SEttInGS
panel (via the
set > 20KHZ LEVELS
option)
Setting the levels of the 20 kHz test signal on the various different audio channels.
8.6.4
ALARM LEVEL
panel (via the
set > ALARM LEVEL
option)
Panel for adjusting the output volume of the Emergency sources: Emergency Microphones and Alarm Messages.
8.6.5
AMPLIFIER tESt tIME
panel (via the
set > AMP SEt tIME
option)
Setting the interval between one PMD amplifier test and the next.
8.6.6
pannello
PASSWoRd
panel (via the
Password
option)
Panel for enabling, disabling and customising the password for accessing the system service levels.
8.6.7
BEEP oPERAtIon
panel (via the
Beep operation
option)
Panel for enabling, disabling and customising the system beep.
< SERVICE >
Connection to the SERVICE menu for technical personnel having the necessary password. It is used to change the operating
parameters of the VAC 2006 system, up-dating the firmware and servicing it.
note:
The settings of the Service Menu are not covered in this Manual.
If an access password has been enabled, at the time of configuration the
ConFIGuRAtIon ACCESS
panel will be displayed:
- enter the four-digit password then press Ok to proceed,
or
- press ESC to return to the MAIN page.
The default password is
3333
.
Once the CONFIGURATION Menu is accessed, all the options illustrated
earlier in the “AUDIO SETTING”, “INSPECTION” and “CONFIGURATION”
menus will be shown, as well as the following new options specific to the
CONFIGURATION menu.
Turn the knob to browse through the options listed:
•
acquire > IMPEdAnCE
•
set > IMP. toLERAnCE
•
set > 20KHZ LEVELS
•
set > ALARM LEVEL
• set > SPEECH LEVEL
• set> AMP SEt tIME
• set > BACKGROUND TEST
• set > CHIME
• report > FAULTS
• report > IMPEDANCE
• status > CONTROL INP.
• test > INDICATORS
INPUT 1
INPUT 2
Firmware Version
Password
Beep operation
<
SERVICE
>
• Exit > Logout
Press Ok to select the required item, or
- press ESC to return to the MUSIC panel.
- press MENU to return to the MAIN page.
The characteristics of the specific panels of the
ConFIGuRAtIon
Menu are illustrated below. For the other available options, refer to the
appropriate sections above.
At the end of the setup, log out by selecting “
Exit> Logout
” as described in point 8.5.5, page 105.
