Fastech Ezi-Step Plus-R, User Manual

Page: 6 / 70

www.fastech.co.kr
6 1. Safety Precautions
◆ The Status of the Product
☞ Check if the product is dama ged or any component is omitted.
When an abnormal product is installed and operated, the user may get
injured.
◆ Install
☞ Carefully move the product.
Dropping the product on the ground or the user's foot may cause an
injury.
☞ Use non-flammable materials like metals in the place where the product
is to be installed.
Otherwise, a fire may occur.
☞ When installing several drives in a sealed place, install a cooling
fan to keep the ambient temperature of the drive at 50℃ or lower.
Otherwise, a fire o r other kinds of accidents may occur due to
overheating.
◆ Connecting Cables
☞ Before connecting cables, check if input power is off.
Otherwise, an electric shock or a fire may occur.
☞ The case of the drive is insulated from the ground of the inte rnal
circuit by the condenser. Necessarily ground the driver.
Otherwise, an electric shock or a fire may occur.
◆ Change of operation and setting
☞ All parameters of the drive were accordingly set at the factory. To
change these parameters, read the manual first.
Otherwise, the machine may be damaged or out of order.
◆ Repair and Check
☞ Stop supplying power to the main circuit , wait for a while, and then
check or repair the drive.
Electricity remaining in the condenser may cause any danger like an
electric shock.
☞ Do not change cabling while power is being supplied.
Otherwise, the user may get injured or the drive may get damaged.
☞ Do not remodel the drive.
Otherwise, the user may receive an electric shock or the drive may
get damaged. The damaged product is not covered by the warranty.
Notes on Installation
1) This product has been designed for indoor uses. The ambient temperature of the room
should be 0℃~55℃.
2) If the temperature of the case is 50 ℃ or higher, radiate heat outside to cool down
the case.
3) Do not install
this product under direct rays or near magnetic or radioactive
objects.
4) If more than 2 drives are installed in a line, keep the interval of 20mm or more
vertically and 50mm or more horizontally.
Caution
Caution
Warning
Caution
Warning