Fastech Ezi-Step Plus-R, User Manual

Page: 58 / 70

www.fastech.co.kr
58 13. Parameter
13.3 Parameter Description
No. Description Unit
Lower
Limit Upper
Limit
Default
0 Pulse per Revolution
:
Number of pulses per revolution.
Vaule ppr Vaule ppr
0 500 8 6400
1 1000 9 8000
2 1600 10 10000
3 2000 11 20000
4 3200 12 25000
5 3600 13 36000
6 4000 14 40000
7 5000 15 50000
0 15 10
1 Axis Max Speed :
When position moving commands (absolute move, incremental move) are
given, this mode sets the maximum speed which the motor can
operate. So, the motor cannot be operated faster than this value
in any case. This value is set to [pps] unit.
pps 1 500,000 500,000
2 Axis Start Speed :
When position moving commands (absolute move, incremental move) are
given, this mode sets the operation start speed to [pps] unit.
pps 1 35,000 1
3
Axis Acc Time :
When position moving commands (absolute move, incremental move) are
given, this mode sets the acceleration section of operation start
segment to [msec] unit.
Possible range is different from
Axis Speed .
(Ex.1) Axis Start Speed=1, Move Speed=400000 : 1~1430 [msec]
(Ex.2) Axis Start Speed=1, Move Speed=10000 : 1~350 [msec]
msec 1 9,999 100
4
Axis Dec Time :
When position moving commands (absolute move, incremental move) are
given, this mode sets the deceleration sect ion of operation stop
segment to [msec] unit.
Possible range is different from
Axis Speed same as ‘Axis Acc
Time’parameter
msec 1 9,999 100
5
Speed Override :
When position moving commands (absolute move, incremental move) are
given, the operation speed i s subject to the rat io set to ‘Move
Speed’. (Ex) If current move speed is 10,000 and speed override
is 200, actual motion speed is set to 20,000.
% 1 500 100
6
Jog Speed :
When jog position moving command is given, this mode sets the
motor revolution valu e to [pps] unit.
pps 1 500,000 5000
7
Jog Start Speed :
When jog position moving command is given, this mode sets the
operation start speed to [pps] unit.
pps 1 35,000 1
8 Jog Acc Dec Time :
In case of jog operation, this mode sets the time of accelerati on
and deceleration sections to [msec] unit.
msec 1 9,999 100
9
Alarm Logic :
When the motor or the drive is defective and so alarm signal
output is ON through CN1 connector, this mode sets the output
signal level.
♦ 0 : 0 V (Active low level)
♦ 1 : 24V (Active high level)
0 1 0