Farmi Forest Mastersplit WP30, Operating, Maintenance And Spare Parts Manual

Page: 24 / 68

MASTERSPLIT WP30
24
• Roll wood on the arms of the loader so that
the top of the wood and the support leg space
between the user in lengthwise direction is ap-
prox. half a meter.
• Ensure the wood remains in the middle of the
arms.
• Lift the loader hook up with your left hand and
carefully push the operating lever forward.
Feed table will move forward and the loader
hook will stay on a cotter on the feed table thus
raising the wood.
• Roll wood onto the feed table.
• Lower the loader arms down.
• With your right arm hold the operating lever and
push the lever forward. The feed table will move
forward feeding wood for cutting. The left hand is
for guiding and holding on to the wood. Move the
wood as far as the stopper plate (stopper). (Note
rapid action. See section” The use of the machine
and the operating principle “.)
NOTE! If the wood
is not moving with the feed table, help by pul-
ling it with your left hand against the moving
feed table.
• If the wood is too thick or there are bends, en-
sure that it does not get caught on the edges of
the feed opening. This kind of operating error
that can cause damage to the machine is not co-
vered by the warranty!
• Pull the operating lever towards the user and the
feed table returns to its basic position and the saw
starts up.
• When the wood is cut it will fall onto the splitting
chute, where a splitting ram pushes the wood to-
wards the splitting blade and simultaneously the
feed table feeds new wood for cutting.
• NOTE! If the tree will not split with the rapid
movement, pull the handle towards yourself,
this will increase the splitting power. If the
tree does not split even when using the higher
splitting power, do not continue the splitting
as the oil in the machine will overheat fast and
the machine might get damaged. This kind of
operating error that can cause damage to the
machine is not covered by the warranty!
• Adjust the splitting blade height if required. (See
section: “Splitting machine operating adjust-
ments”.)
• Continue sawing until the last piece of wood re-
mains. (While sawing, always hold on to wood
with your left hand.)
CRANK
AUXILIARY
PLATE
• Move the last piece of wood on the feed table’s ( not
by hand!
) auxiliary plate and return the feed table
to its original position. Then return the crank with
your left hand allowing the wood to fall onto the
splitting chute for splitting.
• NOTE! If the diameter of the wood is so wide
that it catches the opening of the feeder ensu-
re that it cannot move to the vertical position,
thus this may damage the framework. This
kind of operating error that can cause damage
to the machine is not covered by the warranty!
• Do not insert your hand inside the safety grill. If
the piece of wood does not move on the feed tab-
le immediately, repeat the action.
• Ensure that the splitting pile beneath the con-
veyor does not get too high. A high pile may cause
the conveyor to break.
• If the conveyor begins to build up wood, apply it
gently slopied.
(NOTE! Maximum angle with res-
pect of the operating base is 40
o
.)
• Take hold of the crank on the top of the machine
with the left hand (with the right hand still holding
the operating lever) and push the crank away from
you. The stopper moves upwards and the auxiliary
plate swings upwards (see the following figures).