Farmi Forest Mastersplit WP30, Operating, Maintenance And Spare Parts Manual

Page: 17 / 68

MASTERSPLIT WP30
17
MOBILE TRANSPORTATION BASE (extra equipment)
The transportation base can only be installed if it is
ordered together with the machine.
• Find a solid and even base for the machine.
• Release the machine from the vehicle’s coupling
hook.
• With the cam gear adjust the machine’s pulley
shaft from the horizontal to a slightly downward
angle so that the rear support leg is higher.
• After this lower the rear support leg on the ground,
with the cam gear, adjust the pulley shaft of the
machine from the horizontal to a slightly upward
angle and lower the front support leg down to the
ground. Then, adjust the pulley shaft with the cam
gear into the horizontal position. Lastly, lower the
shaft’s support leg and loosen the cam gear. This
will assure that the machine is firmly on its base.
• Unlock the fixed feed table (behind the moving
feed table) and pull the feed table backward
against the table’s support. Ensure that the table
is locked in its place.
• Next see section “Preparing the conveyor for ope-
ration”. Take action accordingly.
• Switch the splitting machine on idle running and
check that the belt is rotating flawlessly and runs
through the middle of the conveyor.
• Adjust the wood length regulator to the desired
position (see section: ”Adjustment of the length of
the split wood”).
• Ensure that the operating lever is locked. See the
figure below.
OPERATING LEVER
FILTER
LOCK
• Start the splitting machine (tractor on idle run-
ning) and check that the conveyor belt is rotating
flawlessly and runs through the middle of the con-
veyor. (Fasten, if required, see section: “Conveyor
belt adjustment”).
• Hold the operating lever with the right hand
(for the correct kind of gripping, see the figures
shown). Use the left hand to turn the lock of the
operating lever upwards and then pull the opera-
ting lever carefully towards you. At the same time,
the feed table moves back to the rear position.
• NOTE! Always wear personal protective equip-
ment when operating the machine. The filter on
the hydraulic oil tank can heat up during machine
operation.
CAUTION!
!