Farmi Forest Mastersplit WP30, Operating, Maintenance And Spare Parts Manual

Page: 22 / 68

MASTERSPLIT WP30
22
CONVEYOR BELT ADJUSTMENT
(see figures below)
• NOTE! The tension of the conveyor belt has not
been adjusted before delivery.
• Check the conveyor belt tension always before
usage.
• Lower the conveyor head with the winch to a
height of about one meter (the conveyor must be
on the operating position extension part straight.)
and adjust the belt by the screws at the end of the
conveyor so that the belt rotates faultlessly. (Does
not rub against the sides and does not slip off the
driving roller).
• If required, tighten or loosen the conveyor belt
using a 19 mm spanner.
WORKING WITH THE SPLITTING
MACHINE
This section illustrates working with the splitting ma-
chine.
• Selecting the place for working.
• Checks before use.
• Working methods
SELECTING THE PLACE FOR WORKING
When acquiring and gathering wood it would be ad-
visable to pay attention to the requirements and limi-
tations of the splitting machine. Mastersplit has been
designed to be operated easily and swiftest operating
as possible.
The machine must always stand on
firm and level ground. A tipping ma-
chine may cause impact and crus-
hing hazard for any person staying
near the machine. When working
with the machine, always make sure there is no other
person who might be endangered by the machine
(the danger zone of the machine encompasses 10 me-
ters).
Mastersplit has been designed for the operation by
one person only!
Working in the forest
• Pile the wood on an even and solid surface.
• Allow plenty of space around the machine for wor-
king.
• Make the vehicle path as straight as possible and
take note of the space that the combination requi-
res when planning the turning points into woods.
Splitting wood directly into storage
• Before hauling the wood, move the splitting ma-
chine on a solid and even working area and define
the working areas as required.
• During winter, place, for example, sand to prevent
slipping.
• Ensure that you are able to see the top end of the
conveyor so that you can assess when the storage
is filled up.
CAUTION!
!