Farm King 1460, Operator And Parts Manual

Page: 31 / 168

Assembly - Fertilizer Applicator 1460
31
Coulter Installation
Figure 3
Locate the center of the toolbar. Measure out from the
center of the toolbar and place a mark at the desired
spacing (30”, 22”, 20”)
[Figure 3] .
Figure 4
Align two clamp plates (Item 1) [Figure 4] on either side
of the toolbar at a marked location (30”, 22”, 20”).
Align two clamp castings (Item 2) [Figure 4] over the
holes of the front plate.
Install four 1/2” x 7” bolts (Item 3) [Figure 4] through the
clamp castings and clamp plates. Attach using four 1/2”
lock nuts.
Continue to install clamp plate / casting assemblies along
the toolbar at the desired spacing (30”, 22”, 20”).
Figure 5
Remove cotter pin (Item 1). Loosen the two clamp set
screws (Item 2), then slide the shaft (Item 3)
[Figure 5] of
the coulter assembly up, into the clamps.
Tighten set screws and reinstall cotter pin.
Continue to install shaft / coulter assemblies along the
toolbar.
B-11000
CENTER OF TOOLBAR
When installing the coulters, the toolbar and wings
must be level and supported.
Coulters cannot be installed if there is an
obstruction along the toolbar.
If an obstruction is in the way of the desired
spacing, install the coulter mount just past the
obstruction along the toolbar. Use an offset shank
and swing the assembly back to align with the
proper spacing.
B-11031
3
2
1
2
B-11032
2
1
3