Farm King 1460, Operator And Parts Manual

Page: 48 / 168

Operation - Fertilizer Applicator 1460
48
Connecting Hydraulic Hoses
NOTE: Make sure the quick couplers are fully
engaged. If the quick couplers do not fully
engage, check to see that the couplers are the
same size and type.
NOTE: Hydraulic hoses marked with two colored
markers (tape) is the pressure line. Hydraulic
hoses marked with a single marker (tape) is
the return line.
To Connect:
Figure 26
Push coupler into female coupler on the tractor until they
are fully engaged and locked
[Figure 26] .
1. Transport Circuit (Red Tape): Wing Fold / Unfold
(Item 1).
2. Work Circuit (Blue Tape): Toolbar Raise / Lower (Item
2).
3. Pump Circuit (White Tape): Liquid Pump (Item 3).
Connect the return line (single wrap) of the pump circuit
to “case drain” if available.
To Disconnect:
Release pressure and pull the male coupler out to
disconnect.
Connecting Electrical Harness
Connect the fertilizer applicator's 7 pin electrical harness
(Item 4)
[Figure 26] to the tractor’s electrical system.
Lower jack until weight of equipment is resting on tractor
drawbar. Pull lock pin on jack and rotate to storage
position and secure with lock pin.
HIGH PRESSURE FLUID HAZARD
To prevent serious injury or death from high
pressure fluid:
• Relieve pressure on system before repairing or
adjusting.
• Wear proper hand and eye protection when
searching for leaks. Use wood or cardboard
instead of hands.
• Keep all components in good repair.
• Contain and dispose of any oil leakage in an
environmentally safe manner.
• Thoroughly clean the quick couplers before
making connections. Dirt can quickly damage
the system.
B-0145
1
2
3
4
AVOID BURNS
Hydraulic fluid, tubes, fittings and quick couplers
can get hot when running equipment. Be careful
when connecting and disconnecting quick couplers.