Farm King 1460, Operator And Parts Manual

Page: 79 / 168

Maintenance - Fertilizer Applicator 1460
79
STORAGE AND RETURN TO SERVICE
Storage
Sometimes it may be necessary to store your Farm King
fertilizer applicator for an extended period of time. Below
is a list of items to perform before storage.
• Add 20 gal (75 liters) of clean water to the fertilizer
tank and flush out toolbar / wings. Repeat three times.
• Thoroughly wash the machine with a pressure washer
or water hose to remove all dirt, mud, debris or
residue.
• Remove knives, injectors and orifices from the coulter
assembly. Wash thoroughly. Apply a thin layer of
grease to coulter blades/knives and exposed cylinder
shafts to prevent rust.
• Winterize with RV antifreeze.
• Lubricate all bushings to remove any water residue
from washing.
• Remove any material that has become entangled
around any moving part.
• Raise and fold the toolbar and wings into their fully up
and retracted configuration.
• Clean, flush, drain and cover spray monitors to
protect from UV exposure.
• Place hydraulic hoses and 7-pin connector in the
storage brackets.
• Inspect the hitch and all welds on the equipment for
wear and damage.
• Check for loose hardware, missing guards, or
damaged parts.
• Check for damaged or missing safety signs (decals).
Replace if necessary.
• Replace worn or damaged parts.
• Touch up all paint nicks and scratches to prevent
rusting.
• Place the equipment in a dry protected shelter.
NOTE: If a dry protected shelter is not available,
cover with a waterproof tarp and tie down
securely.
• Place the equipment flat on the ground.
• Support the jack / frame with planks if required.
Return To Service
After the Farm King fertilizer applicator has been in
storage, it is necessary to follow a list of items to return
the equipment to service.
• Be sure all shields and guards are in place.
• Lubricate the equipment.
• Connect to a tractor and operate equipment, verify all
functions operate correctly.
• Check for leaks. Repair as needed.
DO NOT permit children to play on or around the
stored machine.