Farlink IP Camera – FL301 / FL501
30
3.9. DI/DO settings (For FL501 only)
The video server product provides DI/DO alarm function; video motion detection
or the digital input signal could trigger the digital output alarm. The duration of the
alarm could also be set. The related settings are explained below:
1. Digital input – can select the normal status of the digital input as either open circuit
or closed circuit. The current status is also displayed.
2. Digital output – can select the normal status of the digital output as either open
circuit or closed circuit. The current status is also displayed.
3. D/O alarm – select the trigger mode of the digital out alarm
A.
Motion trigger – if this is selected, the digital output alarm signal will be
active when video motion is detected. The detection sensitivity is set In the
“motion detection” page.
B.
D/I trigger – if this is selected, the digital output alarm signal will be active
when the digital input signal is detected..
C. Schedule – if this is selected, the digital output alarm is scheduled
according to the settings of scheduling in section 3.11.
D. Active – force the digital output to be active.
E.
Normal–force the digital output to be normal.
4. D/O Alarm duration – this is the digital output alarm duration for each trigger.
Figure 3-14: DI/DO Settings page
Summary of Contents for FL301
Page 20: ...Farlink IP Camera FL301 FL501 20 Figure 3 6 Network settings page for fixed IP address ...
Page 23: ...Farlink IP Camera FL301 FL501 23 Figure 3 9 WiFi testing page ...
Page 34: ...Farlink IP Camera FL301 FL501 34 Figure 3 17 SD Card information page ...
Page 41: ...Farlink IP Camera FL301 FL501 41 Figure 3 23 Firmware upgrade status page ...
