RESTRICTED USE ONLY
Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0)
166
Using the Defined Area(s) function (continued)
Step
Procedure
4
Once the area is sized properly:
Measure the location for this area to be positioned on the card.
Measure from the lower left corner of the card up and over to the lower left
corner for the defined area to begin and enter these values into the X and
Y boxes.
(Note: The card grid lines are spaced at .2 inch / 5mm intervals.)
5
a. Print the card design and note how the image is oriented on the card as it
ejects from the Printer. (Note: The location of a defined area is based on
the card orientation as it exits the Printer.)
b. Measure the defined area location based on the printed card. (Note: If
selecting the Rotate Front 180 Degrees option, the image will appear
upside-down as it exits the Printer. In this case, position the defined area
opposite to the measurement from the onscreen card design, which will
appear right side up.)
Continued on the next page
