RESTRICTED USE ONLY
Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0)
104
Using the Flipper Offset option
Use this option to set the position of the flipper so that it is level with the card path.
Step
Procedure
1
Lower the lead-in of the Flipper Table (or offset the Flipper more clockwise) by
clicking on the down
arrow to enter a negative value.
OR
Raise the lead-in of the Flipper Table (or offset the Flipper more counter-
clockwise) by clicking the up arrow to enter a positive value.
Caution #1: Adjust only
±
1 to avoid accidentally over-adjusting the
Flipper offset.
Caution #2: If the positive value is set too high, the Flipper angle may
be too high causing a card jam. (Maximum Range: The maximum adjustment
range is
±
10.)
