MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL
28
The screw type and length must be able to support the control panel, options and battery set.
You may need a different screw type, depending on the wall material.
Place the backbox over the two top bolts and allow it to slide down over the bolts.
•
Mark, drill, and install the two bottom bolts in the backbox.
•
Tighten all four bolts securely against the back wall of the backbox.
•
The RSE-300 Auxiliary Power Supply or battery enclosure may be mounted immediately
below the main enclosure, close nipple, allowing a minimum of 1 inch in between the
enclosures for clearance between the doors. Keeping the wire run to the control unit short
will keep the voltage drop to a minimum.
•
If a semi-flush mount installation is desired, use the SFTK-6(R/B) Semi-flush Trim for the
MPC-6000 / RND-2 and the SFTK-7(R/B) Semi-flush Trim for the MPC-7000. The backbox
can be mounted up to 3 1/2 inches into the wall. Place the semi-flush trim around the
backbox and affix to the wall with four #10 x 3/4 inch wood screws (provided with trim).
You may need a different screw type, depending on the wall material.
For semi-flush installations, if the RSE-300 Auxiliary Power Supply or a battery enclosure is
required, it may be mounted immediately above or below the main enclosure, close nipple,
allowing a minimum of 3 inches in between the enclosures for clearance between the semi-
flush trims. Keeping the wire run to the control unit short will keep the voltage drop to a
minimum.
MPC-6000 and RND-2 Enclosure Mounting Pictures
