Fanvil i504 Series, User Manual, Page: 79 / 95

78
Ringtone
Duration
When the input interface triggers an alarm, if the alarm sound is
enabled, specify the duration of the alarm sound.
Input &
Tamper
Server
Address
Configure the remote response server address, including the remote
response server address and the triggered alarm server address.
When the input interface or tamper is triggered, it will send a short
message to the server. The server address supports IP:PORT or SIP
number.
Information
The alarm information to be sent:

Parameters can be replaced with actual values. The supported
parameters include:

Model, replace with the actual model name

Active_user, replace with the actual SIP username

Mac, replace with the MAC address of the device

IP, replace with the IP address of the device

Trigger, replace with the triggered interface, such as input1,
input2, etc.

Trigger Name, replace with the triggered name.
Input settings
Parameters
Description
Input 1 Enable or disable Input 1
Triggered by
When choosing the low level trigger (closed trigger), detect the
input port (low level) closed trigger.
When choosing the high level trigger (disconnect trigger), detect
the input port (high level) disconnected trigger.
Input Duration Set the Input change duration time, the default is 0 seconds.
Triggered Behavior
Enable or disable the input port from sending messages to the
server.
Event
Triggered events: When connected to a door magnet, select
door magnet; when connected to an indoor switch, select indoor
switch.
Triggered Ringtone Supports ringtone selection: None, no ringtone triggered.