Fantic Caballero 125 series, Owner'S Manual

Page: 64 / 160

64
off (figure O). You can modify in sequence the
hours and then the minutes based on the se-
lected data (which will be shown flashing with
f=1Hz, Duty=50%).
Clock adjustment (fig. O)
Briefly press the button to increase the selected
parameter by one unit. Press and hold the button
to change from setting the hours to setting the
minutes, followed by exiting setting. The Time
parameter will be shown in the format 0-24 if
the selected unit of measure is km/h.It will be
shown in the format 0-12 if the selected unit of
measure is mph. In this case, during setting, dig-
its 10 and 11 will show the message AM or digits
11 and 12 will show PM as shown in figure P.
Setting the clock in the 0-12 format 0-12 (fig. P)
While in the setup menu, the clock is NOT up-
dated.
Once you have entered the setting menu:
- if no button is pressed for 20 seconds, or
- if the vehicle begins moving (vel>0), or
- (for models without vehicle battery) if the
vehicle is turned off, or
- (for models with vehicle battery) if the
key selector is turned to OFF; the system
will automatically go into standard operat-
ing mode, and any modifications will be
saved.
MODIFICATION OF THE UNIT OF MEASURE
If you press the button to change the unit of
measure, only the symbols km/h and mph will
remain displayed. The selected unit will flash
(con f=1Hz, Duty=50%) (fig. Q).
Press the button briefly to change the selected
unit. Press it and hold it to go back to the screens
in fig. N.
km/h mph
Clock adjustment, modification of units of meas-
ure, and exit from the setup menu (fig. N).
Press the button for the function that you want
to modify or at the “OUT” screen to exit the setup
menu.
SETTING THE CLOCK
If you press the button to set the clock, only those
segments related to this function will remain ac-
tive, whereas the other segments will be turned