38
Exhaust:
Cover it with a plastic bag tightened with rubber bands.
Clutch and brake levers, hand grips, and engine stop button: Cover these
parts with plastic bags.
Air cleaner intake:
Cover the opening with tape or with a rag.
2- Where to be careful
Avoid spraying water with any great force near the following areas:
- Brake calipers and brake pump piston.
- Ignition coil or into the spark plug cap.
- Front and rear wheel hubs.
- Steering bearings.
- Rear suspension system.
- Swingarm bearings.
WARNING
To avoid excessive ageing of the plastic parts and other washable pieces
of the motorcycle, it is suggested that these items must be washed care-
fully. If the washer applies water at high pressure and/or temperature, take
the precaution of maintaining the washer outlet gun at a distance of 30
centimeters minimum, this will ensure the correct gloss of the plastics and
maintain adherence of the self-adhesive labels that decorate the motor-
cycle.
3- After washing
- Remove the plastic bags, and clean the air cleaner intake.
- Lubricate the points listed in the lubrication section (see pag. 41).
- Start the engine and let it run for 5 minutes.
- Check the brakes before operating the motorcycle.
WARNING
Never wax or lubricate the brake disc. Loss of braking and an accident
could result. Clean the disc with trichloroethylene or acetone.
Summary of Contents for TZ 125 2011
