Fantic Motor TZ 125 2011, User Manual

Page: 34 / 72

34
- Pull the hydraulic rod out slowly.
- At this time, the fork oil pours out of the hydraulic rod hole, keep it raised
to let it drain until it stops.
- Install the fork spring (1) inside the fork tube.
- Tighten the suspension spring and insert the wrench (5) in the locknut (2)
to lock the cap (3).
- Install the suspension cap (3) in the fork tube and tighten it to 29 Nm.
- Mount the other fork.
- Install the parts removed.
(1) - Spring
(2) - Locknut
(3) - Suspension cap
(4) - Cap wrench
(5) - Locknut wrench
Suspension tube spring
Di ff erent springs are available in accordance with the rider´s weight or the
road conditions.
- Harder springs make the fork sti ff er, and rebound action quicker.
- Softer springs make the fork softer, and rebound action slower.
Preload: turn adjusting screw (C) clockwise as far as it will go. See page 32.
Standard adjustement MARZOCCHI: turn it counterclockwise as far as it will go.
Suspension top bridge position adjustment
Make sure the front tire does not rub against the fender when the fork tubes
are compressed fully. Make this adjustment to a minimum of 5 mm.
CAUTION
The suspension tubes, both right and left, must be adjusted evenly.