Falcon Excel, Users Manual & Installation And Servicing Instructions, Page: 24 / 61

24
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
on the earth plate beside the oven element connections.
Disconnect the cutout wiring. Undo the fixings that
secure the cutout to the earth plate and remove. Fit the
replacement control and re-assemble in reverse order.
17. To Remove Oven Inner Back
Disconnect from electricity supply.
Open door and remove shelves. Remove screws and
washers, four on the left over as shown in the diagram
and two on the right oven and securing the inner back of
the oven.
Carefully lift away the inner back. Reassemble in reverse
order making sure that the screws and washers are fully
tightened.
18. To Remove the Fan Oven Element
Disconnect from electricity supply.
Remove the oven inner back - see section 17.
Remove the two screws from the top of the element and
the one from the bottom of the element inside the oven.
Lift the element out carefully, disconnecting the terminals
connected to the element (noting their positions). If it
is not possible to disconnect the leads in this way, pull
the cooker forward to gain access to the rear, remove
the screws securing the electric cover to the back sheet,
remove the cover and disconnect the terminals from the
rear.
Fit the new element and reassemble in reverse order.
Check the operation of the oven.
19. To Remove Oven Fan
Disconnect from electricity supply.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet
and remove the cover. Disconnect the three terminals
connected to the fan noting their position. Remove the
oven inner back (see 17). Hold the fan blade and remove
the centre nut (left hand thread) two brass washers, fan
blade and Circlip. Unscrew the fan retaining nuts and
washers (three off each) and lift the fan away from the rear
of the cooker. Fit the new fan and reassemble in reverse
order. Check the operation of the oven.
20. To Remove the LH Oven Bottom and Top Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the
rear of the unit. Remove the fixings that secure the cover
and lift it clear.
Remove the 2 screws ‘A’ and allow the plate to drop down.
Remove the 2 screws B, lower the upper plate and remove
through the slot in the cooker back.
Undo the terminal connections, noting their positions.
Remove the element fixings and withdraw element.
Replace the element and re-assemble parts in reverse
order.
Top Element
Open the LH oven door and undo the fixings that secure
the heat shield. Remove the top element bracket fixings
and withdraw element. Replace the element and re-
assemble parts in reverse order. Check that the oven
operates satisfactorily.
21. To Remove Grill Element
Disconnect from electricity supply.
Remove grill pan from inside the grill compartment,
remove the enamelled front shield from the grill roof, by
undoing the two screws and washers.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.