Falcon Excel, Users Manual & Installation And Servicing Instructions, Page: 20 / 61

20
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
The centre adjuster controls the central front roller; the
outer two control the rear rollers:
Fit the levelling tool to each adjusting nut in turn and
lower the rollers by making 10 complete (360º) turns
clockwise. (This means turning and removing the levelling
tool 20 times.)
Make sure you lower all three rollers.
Unfold the rear edge of pack base tray.
Open the grill door and Slow oven door. With your hands
under the bottom edge of the hot plate facia, lift the front
of the cooker slightly and then roll the cooker on the
rollers.
Unfold the rear edge of the
pack base tray. Carefully
push the cooker backwards
out of the base pack. Push
the cooker close to its final
position, leaving just enough
space to get behind it.
Take care not to twist it within the gap between the
kitchen units as damage may occur to the cooker or the
units.
Do not use the door handles or control knobs to move
the cooker
.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rear rollers and front feet can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use
the levelling tool supplied to turn the adjusting nuts at
the front bottom corners of the cooker.
To adjust the height of the front of the cooker, screw
down the front feet.
Repositioning the Cooker following Connection
If you need to move the cooker once it has been
connected, then you need to unplug it and, having
gripped under the fascia panel and lifted the front of
the cooker slightly (as shown above), you need to check
behind the cooker to ensure that the electricity cable is
not caught. As you progress, ensure that the cable always
has sufficient slack to allow the cooker to move.
When you replace the cooker, check behind it again once
more to ensure that the electricity cable is not caught or
trapped.
Electrical Connection
The cooker must be installed by a qualified electrician,
in accordance with all relevant British Standards/Codes
of Practice (in particular BS 7671), or with the relevant
national and local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
Note:
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating a
double pole switch, having a contact separation of at least
3mm in all poles.
The cooker must not be connected to an ordinary
domestic power point.