18
9 CONSOLE & BUTTON INSTALLATION
The console is designed to fit anywhere on the handlebar that allows correct
use of all other controls. The mount on the reverse of the console can also be
turned sideways to allow it to be fitted to the handlebar stem to give you more
space on your handlebar for lights etc.
Step One:
First of all offer the console up to the handlebar to see where it can be mounted
without interfering with your existing controls. Remember to leave enough
room to access tightening screw on the mount. Also make sure that the button
wire is able to reach the console when it is secured.
Step Two:
Using the zip ties supplied, attach the handlebar mount in the position
required. Once happy it is tied on tight enough, trim the excess from the zip tie.
Step Three:
Attach console to the handlebar mount and fix into position.
Step Four:
Remove the backing clamp from the buttons and put buttons into position.
Once in position refit the backing clamp and bolts to the buttons and secure
into place so that the buttons are held firmly in position.
Note: Tighten the backing clamp bolts evenly so there is even pressure and
distance on both ends of the clamp. This will prevent the bolts from seizing
into position after long periods.
Step Five:
Once you are happy that everything is secured connect the button cable to the
Console and you are ready to operate the console.
Summary of Contents for Intelligent energy management system
Page 1: ...1 INSTALLATION MANUAL OWNERS GUIDE...
Page 30: ...30 12 WIRING INSTRUCTIONS...
