fadini Siti 63, Instructions Manual

Page: 13 / 48

Siti 63
RADIO TRANSMITTER CODE DELETING
page 9
Insert the removable "Strip" jumper on P1 position on the Radio Receiver:
1st Operation: Push the 2nd button on the Radio Transmitter and release when the Led
turns off
2nd Operation: Push the
1st button on the new Radio Transmitter and release when the
Led turns off
Repeat these 2 Operations for
6 times and end the sequence pushing the 1st button.
Then Insert the "Strip" jumper in only one PIN.
Repeat these operations for every transmitter you wish to delete.
N.B: IF THE NUMBER OF OPERATIONS OR THE TIME BEFORE NEXT PRESSING ARE MISTAKEN,
YOU MUST REPEAT THE OPERATIONS FROM THE BEGINNING, AND WAIT 1 MINUTE BEFORE
STARTING AGAIN.
IF YOU NEED TO DELETE A TRANSMITTER CODE OPERATE AT A MAX DISTANCE OF 10 METRES
FROM THE RADIO RECEIVER, DULY POWER SUPPLIED, AERIAL CONNECTED
IMPORTANT : Transmitter deleting is possible even if keys are encoded (see chapter about Birio LC device) provided that they were encoded by the same Birio
LC encoding device.
Siti 63
4 buttons
Siti 63
2 buttons
2nd Operation 3rd Operation
4th Operation
5th Operation 6th Operation
1st Operation
Push 1st button and release
when the led turns off
Push 1st button and release
when the led turns off
Push 1st button and release
when the led turns off
Push 1st button and release
when the led turns off
Push 1st button and release
when the led turns off
Push 2ndt button and release
when the led turns off
Push 2nd button and release
when the led turns off
Push 2nd button and release
when the led turns off
Push 2nd button and release
when the led turns off
Push 2nd button and release
when the led turns off
Push 1st button and release
when the led turns off
Push 2nd button and release
when the led turns off
2nd Operation
3rd Operation
4th Operation
5th Operation
6th Operation
1st Operation
Siti
PLUG-IN RADIO RECEIVER
P1
PIN
REMOVABLE
MEMORY
1°R
2°R
1
2
“STRIP”
JUMPER
LED
Relay
Relay
Relay
EXTERNAL RADIO RECEIVER
1
3
2 4
P1
REMOVABLE
MEMORY
PIN
LED
“STRIP”
JUMPER
page11
Drwg.4091
On/off switch
9 volt 300mA battery recharge connector
Serial cable Personal Computer connector
Memory or transmitter key entering and code
shifting
Transmitter and memory key deletion and
code entering
Copy, replace, delete, copy 1 button of the
transmitter and the memory
POWER SUPPLY: Birio LC device has an internal rechargeable battery, 6 hours autonomy , you can also operate it by 230V 50Hz power supply using a
9V 300mA adaptor. Maximum recharging time is 5 hours.
Power supply led
Button for encoding operations
and memory
Display
Birio
LC
SUPPLY
9 VOLT
ON / OFF
GB
MEMORY
REPLACE
DELETE
COPY ONE BUTTON
COPY
MEMORY
ENTER KEY
DELETE KEY
To fit removable memory
4213
SELECT
CODE
Siti
Siti
Siti
Siti Siti
Siti
Siti
Siti
Siti
Siti
Siti
Siti
Siti