fadini Siti 63, Instructions Manual

Page: 9 / 48

PIN
EXTERNAL
Siti 63
RADIO RECEIVER ENCODING OPERATION
RELAY
1st CHANNEL
RELAY
2nd CHANNEL
(C1) Relay 1 -
1st channel
(C2)
Relay 2 -
2nd channel
PUSH
BUTTON “P”
2nd CHANNEL
N.O. OR N.C.
CONTACTS
TO FIT INTO CONTROL
PANNEL
LED
REMOVABLE
MEMORY
1°R
2°R
AERIAL
1
2
3
4
5
+
–
“STRIP”
JUMPER
POSSIBLE PIN COMBINATIONS
1
1
2
2
C2
P2
C1
P1
page 5
SHOULD 24 V AC – 13 V CC BE INTERRUPTED, THE CODE IS KEPT IN THE REMOVABLE MEMORY AND IT IS POSSILE TO
INSERT IT INTO ANOTHER PC CARD.
1) Insert the removable Memory and supply the Plug-in Radio Receiver by plugging it into the control panel.
2) Insert the
"Strip" jumper into C1 position stimulating the 1R: this corresponds to 3 and 4 terminals (1st Channel)
3) Press simultaneously P pushbutton on the Radio and any pushbutton on the transmitter you intend to operate as 1st Channel, for about 5 seconds. As
storing confirmation the red led will illuminate. Release the
push button P and the push button on the transmitter.
4) Remove the "Strip" jumper and plug it into only one PIN.
5) For 2nd channel storing, operate as above and plug the "Strip" jumper into C2 (stimulating the 2R relay); connect the 2nd channel (NO or NC) then push
the button on the transmitter.
PUSH
BUTTON LED
PUSH
BUTTON
LED
2 pushbuttons
Siti 63
4 pushbuttons
Siti 63
1
3
2 4
(TOTAL MEMORY DELETION)
(TOTAL MEMORY DELETION)
P2
P2
Siti 63
RADIO RECEIVER MEMORY DELETING
EXTERNAL RADIO RECEIVER
REMOVABLE
MEMORY
PIN
LED
1°R
2°R
+
–
24 VOLT AC
POWER SUPPLY
1st CHANNEL
2nd CHANNEL
3rd CHANNEL
4th CHANNEL
1 2
3 4
5 6
7 8
9 10
11 12
AERIAL
“STRIP”
JUMPER
PIN
LED
REMOVABLE
MEMORY
1°R
2°R
AERIAL
1
2
3
4
5
+
–
1
2
“STRIP”
JUMPER
TO FIT INTO CONTROL PANEL
PL
UG
-IN RADIO RECEIVER
page 7
1) )Insert the removable Memory and supply the External Radio Receiver with 24 V a.c. by terminals 1(-) and 2 (+) ; and plug the Radio Receiver into control
panel.
2) Insert the
"Strip" jumper into P2 position
3) Press P pushbutton on the Radio Receiver for about 5 seconds. Release the push button P and the red led will illuminate: memory deleted
4) Remove the "Strip" jumper and plug it into only one PIN
PUSH BUTTON
“P”
PUSH BUTTON
“P”
Siti
Siti
Siti
Siti 63
Siti 63