Bayt 980
PROCEDURE FOR DRILLING AND ATTACHMENT OF THE MIRI 4 ON THE CABINET COVER
2899
n°4x1
n°4x1
1
2
3
4
8
10
11
12
15
18
19
17
5
6
7
9
13
14
16
BA
YT 980
20
21
22
1.
Miri 4
flasher with
Birio A8
aerial
(optional)
2.
Miri 4
flasher cable
with
2 x 1.5 wires
3.
RG58
aerial cable
4.
M5
Screws
(3 pieces.)
5.
Vertical coupling
for Miri 4
6.
Cover
to disassemble, once
the three attachment screws
for the Bayt 980 are removed
7.
Control box
with
Elpro 980
elect. Prog.
8.
Limit switch
with spring trip
mechanism
9.
M8x16 TSEI Stainless Steel
Screws
(2 pieces.)
10.
Limit switch cover
11.
M6x25 TEI Galvanised
Screws
(1 piece.)
12.
Limit switch
spring
13.
Door
lock
14.
Door
15.
Cabinet
door switch
for
general electrical power
disconnection
16.
M8x16 TBEI Stainless Steel
Screw
(1 piece.)
17.
Bayt 980
housing cabinet
18.
Prit 19
keyed selector switch
(optional)
19.
Polo 44
Photocell
(optional)
20.
M8
Nut
21.
Lock stop
cabinet side
hole
cover
22.
Protective
cover cap
23.
Ø10.5
Central stud drill hole
24.
Ø4.2
-3 studs drill holes
VIEW OF THE COVER
FROM BELOW
FIG. 17
FIG. 19
FIG. 18
In order to install the Polo 44 photocells and the Prit 19 selector switch on the housing cabinet, it is necessary to remove the
protective covers
(22) unscrewing the
M8 nut
(20) from inside of the cabinet and then removing the
stop plate
(21) (Fig. 19). The
housing cabinet
is in this way
prepared for the attachment of all of the operational accessories (Fig.18).
23
24
- Loosen and remove the
three "M8" attachment screws
(9 and 16) of the
cabinet cover
(6) (Fig. 18).
- Turn the
cover
(6) upside down and drill with a 4.2 mm diameter bit and thread the three M5 studs (24) for the attachment of the
"Miri 4"
flasher (1) (Fig. 17).
- The central stud of the cover (23) must be drilled out with a 10.5 mm diameter bit to enable the passage of the electrical power supply cable for the
"Miri 4"
flasher and for the possible insertion of the
"RG58"
coaxial cable for the
"Birio A8"
aerial (Fig. 17).
- Then run the electrical cables through the central 10.5mm diameter hole and attach the vertical coupling (5) for the
"Miri 4"
flasher (1) with the three
"M5"
screws (4) on the outside of the cover (Fig.18).
- Replace the cover on the
housing cabinet
(Ref. 17) and attach it with the three M8 screws so as to cover the Bayt 980 cabinet, as shown in Fig. 18.
page
9
Made in Italy
the gate opener
l'apricancello