Factory Five Racing GTM Supercar, Assembly Manual

Page: 557 / 764

548
www.factoryfive.com 508-291-3443
Once you have determined that you can wrap the material around the roll bar without wrinkling the
material, placing the exposed edge in a place that will be covered by the body and the material reaches all
the way across, begin applying the adhesive to the foam then wrap the material around the roll bar. Make
sure to spray the adhesive on the back of the material as you begin to overlap the material so it will stick
to itself. Taping along the edge where the material overlaps provides the best seal and prevents the
adhesive from bleeding through in an area that is visible.

Do not apply too much pressure to the tape/material just in case the adhesive has not fully set –
you don’t want the adhesive to bleed through the material.