Factory Five Racing GTM Supercar, Assembly Manual

Page: 549 / 764

540
www.factoryfive.com 508-291-3443
Interior - Rear Wall

¼”, 25 /
64
”, ½” drill bits, drill, clamps, marker, tape measure.

Secondary body fasteners, Aluminum Rear Wall (FFR# 25271), Upper Cockpit Sidewall Brackets
(25741, 25742), Fuel Tank Covers (FFR# 25195, 25196).

Slightly rounding off the edges of the rear wall with a grinder/sander aids in installation of the
rubber push-on trim onto the rear wall.
Cut two pieces of the rubber push-on trim (FFR# 10761) 9” long and push the trim onto the outside edges
of the rear wall.
Cut a 41” section of the rubber push-on trim and press the trim onto the rear wall.
Set the rear wall in the car so that the bulb seal contacts the body with just enough pressure to create a seal
between the trim and the body – do not press the rear wall up to the body so hard that the bulb seal is fully
crushed. Make sure that the holes in the panel for the rivnuts are near the center of the 1” square tubes.
Clamp into place