Page
20
with
33
Page
20
with
33
Page
20
with
33
Page
20
with
33
MANUAL - WELDER Fantasy PULSE BI-201
G. MIG / MAG WITH DOUBLE PULSE
G. MIG / MAG WITH DOUBLE PULSE
In order to start welding mode MIG / MAG PULSE be double pre-made settings as in Chapter
BASIC SETTINGS
In order to start welding mode MIG / MAG PULSE be double pre-made settings as in Chapter
BASIC SETTINGS
MIG / MAG welding. Additional welding parameters in the welding mode, double-pulse current shown in the following
MIG / MAG welding. Additional welding parameters in the welding mode, double-pulse current shown in the following
tables:
Selecting the welding current
3 -
double pulse
Selecting the welding current
3 -
double pulse
Selecting the welding current
3 -
double pulse
Selecting the welding current
3 -
double pulse
Setting the maximum speed wire feeder.
ATTENTION!
When adjusting this parameter should pay particular
attention to the box marked red
trademarks
"X"
pointing
suggested the plate thickness.
Setting the frequency of the double pulse. In order to
achieve optimum welding parameters is suggested to set
the range of 1 to 2 Hz.
Setting the cycle of the double pulse. In order to achieve
optimum welding parameters is suggested that the setting in
the range of from 30 to 40%.
