Page
19
with
33
Page
19
with
33
Page
19
with
33
Page
19
with
33
MANUAL - WELDER Fantasy PULSE BI-201
F. MIG / MAG Pulse
F. MIG / MAG Pulse
In order to start welding mode MIG / MAG PULSE be pre-made settings as in the previous chapter. Additional
welding parameters in pulsed mode welding shown in the following tables:
Selecting the welding current
2 -
single pulse of the pulsed
Selecting the welding current
2 -
single pulse of the pulsed
Selecting the welding current
2 -
single pulse of the pulsed
Selecting the welding current
2 -
single pulse of the pulsed
current function, is used mainly in welding of thin
elements, metals having a low melting point, eg. lead,
and in welding forced positions. Other advantages of
pulsed welding is less heat-affected zone, the greater the
stability of the welding arc and the greater the depth of
penetration and improving the appearance of the weld
face.
Adjusting the frequency of the pulse. Changing this
parameter results in lengthening or shortening the arc.
ATTENTION!
Frequency
pulse
selected
is
automatically on the basis of other welding parameters,
there is no need for manual correction dokonowyania
her.
Setting cycle pulse. Control
this
parameter
causes
increasing or decreasing the amount of spatter during
welding.
ATTENTION!
Value
cycle
pulse selected
is
automatically on the basis of other welding parameters,
there is no need for manual correction dokonowyania
her.
