Page
28
with
33
Page
28
with
33
Page
28
with
33
Page
28
with
33
MANUAL - WELDER Fantasy PULSE BI-201
MAINTENANCE
Regularly remove dust with clean compressed air. If the unit is in working conditions in the smoke, in the heavily
polluted air every day remove accumulated dust.
Air pressure should be maintained at a level not to damage the small components inside the machine max. 2-4 bar.
Inspect the internal welder circuits, check the accuracy and reliability of connections (in particular equipment and
parts). In the case of notice of rust and loosening of the connection remove rust and oxide coating with abrasive
paper, and re-connect securely. Avoid situations where water or steam could get into the device. In the case of
welding moisture should dry it, and then check the insulation of the device (also between calls and contacts). After
checking that everything is in order, you can continue working.
ATTENTION !
When welding components which form an integral part of the vehicle it is essential to disconnect the battery or use
special protection. Otherwise, the electronic parts of the vehicle can be permanently damaged. When welding to
connect the handle mass close as possible to the weld site.
SET CONTAINS:
-
Welder power source Fantasy PULSE model BI-201
-
welding torch for MIG / MAG
-
earth wire
-
shielding gas conduit
-
manual Eng
ATTENTION !
The content of this manual has been prepared by a team of engineers skilled in the art. Copying and distribution of the manual, in whole
or in part, without the written consent of The skilled person is prohibited.
MADE FOR:
FHW FACHOWIEC Zenon Świętek Street.
Stefanski 29, 61-415 Poznan
Made in PRC
