42. Working from the driver side, locate the body mount
on the driver side of the frame. Measure & mark 1 1/2”
forward of the body mount and 1” up from the bottom
of the frame. Use a 1 1/2” hole saw and drill through the
front half of the frame only. Do not drill the inside of the
frame.
SEE FIGURES 90-91.
43. Mark and cut the same body mount on the passenger
side of the Jeep as done on the passenger side. There is
a factory hole in the frame on the passenger side, so you
will not need to make the 1 1/2” hole on this side.
44. Locate FT50312BK & FT50313BK Rear Frame Pockets.
Position the bracket onto the bottom of the frame 2”
forward of the previously trimmed body mount. Mark the
holes in the bracket onto the frame. Remove the bracket
from the frame and drill the holes only into the face of the
frame. DO NOT drill into the back of the frame. The two
bottom holes and two front holes need to be drilled to
1/2” and the center hole needs to be drilled to 9/16”.
SEE FIGURE 92-95.
FIGURE 88
FIGURE 89
FIGURE 90
FIGURE 91
1 1/2” FORWARD OF THE BODY MOUNT
FIGURE 92
1/2” HOLES
9/16” HOLE
1/2” HOLES
1” UP FROM THE BOTTOM OF THE FRAME
22 of 31
