REAR SUSPENSION
35. Jack up the rear end of the vehicle and support the frame
rails just in front of the rear bumper with jack stands.
NEVER WORK UNDER AN UNSUPPORTED VEHICLE!
Remove the rear tires. Support the rear axle. Do not
allow to hang freely.Install rear shocks using FTS7333
Performance shocks or FTS810151 Dirt Logic shocks with
factory hardware. Torque to 100 ft-lbs.
34. Locate FT50359 Sway Bar Retainer and the supplied ¼”x
1¼” hardware. Disconnect the sway bar from the lower
axle mounts. Rotate the sway bar end links up toward
the coil bucket and attach the retainers to the end links.
Position the retainer bracket to the coil bucket and mark
the bucket for the retainers. Mark the two holes from the
retainer to the bucket. Lower the retainers and drill the two
new holes to 1/4”. Attach the retainer to the coil bucket,
then attach the end link to the new retainer with the sway
bar pin & lynch pin. After test fitting, re-attach link to axle.
SEE FIGURES 60-65.
FIGURE 60
FIGURE 61
FIGURE 62
FIGURE 63
FIGURE 64
FIGURE 65
17 of 31
