25. Attach the assembled upper link arm to the lower link arm
that is already installed on the Jeep using the supplied
7/16” x 3 ¼” hardware. Then attach the upper link arm to
the front axle using the supplied 10mm x 80mm hardware.
Leave loose at this time.
SEE FIGURES 38-39.
24. Install the assembled link arm to the axle with the
supplied alignment cam bolt and washers first, then
attach the other end of the link to the pocket in the new
crossmember using the supplied 9/16” hardware. (When
attaching the lower link to the Jeep, the pivot end on the
frame mount will need to have the grease fittings facing
down and the pivot end on the axle will need the grease
fitting facing down after the joints are installed on the
Jeep) . Tighten the cam bolts & torque the 9/16” bolts to
**184 ft. lbs.
SEE FIGURES 35-37.
FIGURE 35
FIGURE 36
FIGURE 37
FIGURE 38
FIGURE 39
INSTALL GREASE FITTING DOWN
12 of 31
