26. Locate the front bumpstop spacer and hardware and
place into the bottom of the new front coils. Install the
new coil spring up onto the coil bucket and then onto
the spring perch on the axle. Rotate the coil spring so
that the end of the coil is seated in the perch. Attach the
bumpstop spacer onto the previously drilled axle mounts.
SEE FIGURES 40-43.
27. Locate the Fabtech shock FTS7188 (Not included in
the kit), the supplied ½” x 2 ½” bolts, USS and SAE
Flat Washers, and C-Lock Nuts. Use the supplied lower
bushings and sleeves (FT402087 Sleeve) from the kit
(discard lower bushings & sleeves provided with the
shocks). Attach the bottom of the shock to the stock
lower shock mount. Use two flat washers on the outside
of the mount and two large USS washers on each side
of the shock bushing on the inside of the mount. Use the
upper bushings provided with the shock for the upper
location.
SEE FIGURES 44-45.
FIGURE 40
FIGURE 41
FIGURE 42
FIGURE 43
FIGURE 44
FIGURE 45
MAKE SURE FACTORY UPPER COIL ISOLATOR IS INSTALLED BEFORE
INSTALLING COIL SPRINGS
MAKE SURE COIL SPRING IS
PROPERLY INDEXED IN COIL
SEAT
LARGE USS WASHERS
13 of 31
