G
G
ATE
ATE
O
O
PERATOR
PERATOR
I
I
NSTALLATION
NSTALLATION
G
ATE
O
PERATOR
B
OLT
D
OWN
To align the operator to the gate and bolt it down:
1. Remove the gate operator cover and place the operator on the concrete pad. Position the operator as determined in “Gate Operator
Location. Make sure the gate and operator are parallel and level with each other.
2. Mark the mounting holes and remove the operator. Drill the mounting holes to the required depth and diameter for the sleeve anchors
being used. It is recommended to use 3/8” x 4” sleeve anchors. The use of sleeve anchors allows greater flexibility and makes the
installation and alignment much easier.
3. Clean the mounting holes and install the sleeves. Position the operator over the anchors. Recheck to make sure the gate and operator
are parallel and level with each other. Tighten the anchor bolts to securely hold the operator.
M
EASURE
& W
ELD
T
HE
G
ATE
A
RM
To determine the arm length in a standard location:
1. Make sure the Arm, Operator, and gate are level with each other.
2. A = Measure 46” from gate hinge out on gate.
3. B = Measure 35.5” for Long Arm length.
4. C = Measure 29.5” for Short Arm length.
5. Use the “Gate Operator Location Charts” for optional dimensions.
6. Mark all points and remove arm before welding.
7. With the arm disconnected, weld the arm, arm bars and brackets.
C
ONNECTING
T
HE
G
ATE
A
RM
1. Make sure the power switch is OFF before connecting the arm assembly.
2. Place the Arm Connector over Output Shaft.
3. Manually move the gate to align the arm with the Output Shaft and insert the Sheer Pin.
4. Move the Release Handle down to tighten.
5. The Release Handle Nut Plate may be removed to adjust the Release Handle position if needed. Reconnect the plate when adjusted.
6. Attach the top Arm Cap Cover.
A
B
Long Arm
E
C
Short Arm
IMPORTANT! Always disconnect the arm and arm connectors before welding to
prevent damage to the gate operator and its electronics.
!
CORRECT INSTALLATION
INCORRECT INSTALLATION
DSW2000 Swing Gate Operator
10