I
I
MPORTANT
MPORTANT
S
S
AFETY
AFETY
I
I
NFORMATION
NFORMATION
M
ANUAL
R
ELEASE
:
To manually release the gate operator:
1. TURN POWER OFF! Use the emergency release/shut off only when the gate is not moving. Make sure power for the gate operator is
OFF by using the On/Off switch located inside the cover on the left side of the controller.
2. Remove the top arm cap cover.
3. Lift the Release Handle.
4. Remove the Sheer Pin.
To reengage the gate operator:
1. Make sure power is OFF!
2. Manually move the gate to align the arm with the output shaft and insert the Sheer Pin.
3. Press the Release Handle down until tight.
4. Attach the top arm cap cover.
5. Turn power on. Make sure the gate and all reversing devices are operating correctly.
G
ATE
O
PERATOR
S
PECIFICATIONS
:
Class of Operation .................................................................... Class I, II
Type of Gate ............................................................................. Vehicular Swing Gate Only
Horse Power ............................................................................. 1/2 HP, 500 Watt
Power Input ............................................................................... 120 VAC
Current ......................................................................................
Cycles/Hour .............................................................................. 60
Travel Speed ............................................................................ 90 Degrees In Approx 14 Seconds
Maximum Gate Weight ............................................................. 750 lbs
Maximum Gate Length .............................................................. 18 Feet
Primary Entrapment Protection ................................................. Inherent Current Sensor
Secondary Entrapment Protection ............................................ Provisions for Non-Contact & Contact Sensors
23.5” D
eep
18” Deep
18
.5
” D
ee
p
DSW2000 Swing Gate Operator
6
