FAAC DAAB EP104 V4.08, Manual, Page: 56 / 60

CHANNEL LIST DAAB AUTOMATIC CONTROL UNIT EP104 4.08
56 Channel list edition 1 for EP104 version 4.08
Error messages
Grey background means that the automatic control unit must be restarted (power off) in order to reset the error message.
Error
code
Meaning
Possible cause
EP-1
Not an error code – indicates the type of EP104
in use
EP-2
Not an error code – indicates the type of EP104
in use
E000
No error, shown to acknowledge a change in the
service channel.
E003 Limited running time exceeded Gears slipping? Check C403
E008 Momentary loss of 24 V Momentary 24VDC short circuit?
E015 Loss of mains power
Has there been a power failure? Mains power switch
operated?
E016 Momentary loss of mains power Short mains power failure less than 0,5 seconds
E017
Safety edge or load guard triggered five times in
succession
It something preventing the door reaching the closed
position?
E020 Voltage too high in safety circuit
The voltage measured by the automatic control unit is too
high.
E021 Voltage too low in safety circuit Check external safety circuit, terminal 7-12
E025 Incorrect setting for personal protection, motor 1
Check C200 and C230, the load guard cannot be disabled
with personal protection activated. Check C211, it cannot
be longer than 0.06 seconds. C212 cannot be longer than 2
seconds. C493 cannot be longer than 0.20 seconds.
E026 Incorrect setting for personal protection, motor 2
Check C200 and C240, the load guard cannot be disabled
with personal protection activated. Check C211, it cannot
be longer than 0.06 seconds. C212 cannot be longer than 2
seconds. C493 cannot be longer than 0.20 seconds.
E027
Incorrect setting for motor protection, low limit
inactive
If C202 is not set to 4 C201 may not be set to 1. C201 is only
used with a frequency converter.
E028 Brake selected when using a frequency converter Check that C495/C496 is set to 0.
E032 Limit switch L.O1 has lost its position
Is the limit switch cam bypassing the switch? Loose
connection in switch?
E033 Limit switch L.C1 has lost its position
Is the limit switch cam bypassing the switch? Loose
connection in switch?
E034 Limit switch L.O2 has lost its position
Is the limit switch cam bypassing the switch? Loose
connection in switch?
E035 Limit switch L.C2 has lost its position
Is the limit switch cam bypassing the switch? Loose
connection in switch?
E040 Invalid selection in the service channel
E044 Hidden channels shown
E046 Opening counter reset
E047 Factory reset of all channels
E048 Error code list reset
E050
Unknown circuit board, EP104 or Light not fully
equipped
Contact FAAC Nordic AB
E051
Incorrect software, full version programmed in
EPLight
Contact FAAC Nordic AB
E052
Incorrect software, EPLight software programmed
into a fully equipped EP104
Contact FAAC Nordic AB
E116 No safety edge acknowledgement
Only applies to up-and-over control, fault in safety edge?
Correct run-on time?
E141 SE.O2 is disabled when C104=3