28
User Manual
ECO 200
Service Diagnosis
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D-69239 Neckarsteinach
Tel.: 06229 7000, Fax: 06229 70067
E-Mail: [email protected], Internet: http://www.fuddruck.de
6.2.1 Error Level 1
In this error status all printer functions are still allowed. After warning-message(s) have been deleted by
depressing the CLEAR-key, the printout will be started, which can be incorrect. With this error category most
of the time incorrect control sequences or object sequences by the user are the reason. As far as possible,
these are replaced by standard values.
WARNING-messages can always be erased by depressing the CLEAR-key.
Reaction of red LED: blinking slowly
The first display line contains the error category and the error number,
the second display line hints at a possible error source.
Deviating from this standard reaction to warnings further possibilities can be set via the menu:
Menu: PRINTER INFOS / Warnings / confirm
This menu corresponds to the above description. Warnings are deleted by depressing the CLEAR-key.
Menu: PRINTER INFOS / Warnings / display only
Warnings are displayed as usual, but do not have to be confirmed by the user. The printing process will not
be interrupted.
Menu: PRINTER INFOS / Warnings / ignore
Warnings are neither displayed, nor do they have to be confirmed. Via status request and status display they
can be called in.
Menu: PRINTER INFOS / Warnings /
√
ignore #70
Warning #70 (character?) will be completely ignored and is preset as a standard in the printer.
6.2.2 Error Level 2
In this status all printer functions are allowed, but it can no longer be printed. This error category most of the
time shows serious label set errors, memory overflows or paper errors. Paper errors can normally be
cleared. Other errors require in the main a switching off and on of the printer.
ERROR-messages cannot be deleted via CLEAR-key.
Reaction of the red LED: blinking quickly
The first display line contains the error category and the error number,
the second display line hints at a possible error source.
6.2.3 Error Level 3
In this status all printer functions are allowed, but it can no longer be printed. This error category concerns
either an incorrect printer configuration or a hardware error.
An incorrect printer configuration means for example a logged-on cutting device, although no cutting device
is connected. If this is triggered, a hardware error message is the result. Hardware errors due to incorrect
printer configuration can be resolved by the user. This is not the case with pure hardware errors. Here, the
user has to contact the Service Department.
HARDWARE-messages cannot be deleted via CLEAR-key.
Reaction of the red LED: blinking constantly
The first display line contains the error category and the error number,
the second display line hints at a possible error source.
HARDWARE #240
cutter
WARNING #023
control sequence
ERROR #185
insert memory
