User Manual
ECO 200
Operating
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D-69239 Neckarsteinach
Tel.: 06229 7000, Fax: 06229 70067
E-Mail: [email protected], Internet: http://www.fuddruck.de
17
Dispensing Position
- 000 - 999 steps
To the position of the start of the label an additional forward feed is effected in order to remove the
previously printed label.
Parameter: d = dispensing position * 8 / mm in number of motor steps
After each dispensing operation and after the label has been removed, the next label will be re-positioned to
the start of the label.
The dispensing position will be ignored should the cutting device be logged-on.
Cutting Position
- 000 - 999 steps
To the position of the start of the label an additional forward feed is effected in order to cut the previously
printed label.
Parameter: d = cutting position * 8 / mm in number of motor steps
The cutting position describes the distance between the thermal print head and the cutting device. This
normally lies at 19.8 mm (d=158). By changing this value the cutting position can be moved.
After each cutting operation and before the next printing process, the label will be re-positioned to the start of
the label.
The cutting position will only be considered, should cutting device be logged-on.
TOF-Offset
- 00 - 99 steps – 50
Distance between start of printout to label edge.
d = number of input steps (motor steps)
image heigth
TEXT
TEXT
image abord
TOF-offset
paper end min.
image width
99
0
print direction
thermal print head with print
