User Manual
ECO 200
Operating
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D-69239 Neckarsteinach
Tel.: 06229 7000, Fax: 06229 70067
E-Mail: [email protected], Internet: http://www.fuddruck.de
19
3.3.6 Printer Specs.
Printer - Mode
- without Print key
- with print key
Printing is only possible by depressing the PRINT-key.
Automatic paper sensor
- start ?
When switching to another label paper there might incur problems with synchronization, should both paper
types be very different. In order to guarantee a reliable synchronization, it might be necessary to carry out
the following option.
Before starting the printout the paper sensor has to be positioned at a part of the label which has not yet
been printed. In the case of an incorrect measuring the notice ERROR appears on the screen. In order that
the printer retains the change made when subsequently switched on, the new information has to be
committed to memory. For that you have to select the option manual paper sensor and store it with the
SAVE-Key.
Manual paper sensor:
- 0 - 127 LED
For determination of the optimum sensor
adjustment.
STATUS-button - decrease sensor current
CLEAR-button - increase sensor current
Proceeding:
8. The label material has to be positioned with the
carrier in the area of the paper sensor.
9. The point of switching A determine: of - after *
10. The label has to be positioned in the area of the
paper sensor
11. Point of switching B determine: of * after –
12. The correct sensor value Z is the mean value of
the two measurements.
Dispensing
When dispensing labels, the label has to be transported after printing so far, so that it can be taken out
easily. Time of taking the label out will either be monitored by label-taken (option) or by means of operation
of the print-key. Dispensing position 0 corresponds to the positioning at the start of the label. In order to be
able to take the previous label, the value for the dispensing position has to be increased.
- no
- with print key
After the print job is finished the paper will be reset to the dispensing position for enabling the take- or tear-
off of the label. After pressing the print key it turns again back in the printing position and the next print order
can be carried out.
- with label taken
The label-taken-device can be installed as an option. The device ensures that the next label will only be
printed if the previous one has been taken out. A dispensing position > 0 always means, that the following
label has to be repositioned before printing takes place.
Logging-on of the label-taken-device is only possible – label taken without the cutting device. The dispensing
position will be ignored in case the cutting device is logged-on.
switching points
sensor current
-
*
hysteresis
hysteresis
-
*
0
127
C
L
C : carrier material
L : label
A : measuring point 1
B : measuring point 2
Z : ideal value
* : scan material
- : do not scan material
A
Z
B
Z = (A+B) / 2
1st measuring
2nd measuring
