User Manual
ECO 200
Service Diagnosis
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D-69239 Neckarsteinach
Tel.: 06229 7000, Fax: 06229 70067
E-Mail: [email protected], Internet: http://www.fuddruck.de
27
6.2 Error Correction
Error Description
Reason for Error
Error Correction
No green LED
Mains Cable
Mains Plug
Mains Fuse
Internal Power Supply defective
Change Mains Cable
Establish correct contact
Change Mains Fuse
Manufacturer Service
No printed image
Print Parameter incorrect
Transfer ribbon inserted
incorrectly
Thermal Paper incorrect
Transfer ribbon of other quality
Adjust print parameter anew
Insert transfer ribbon (according to
drawing)
Use material recommended by
manufacturer
Use transfer ribbon recommended by
manufacturer
Label material is transported
insufficiently (buckled printed
image)
Dirty Transport Rollers
Clean transport rollers (see 4.3)
Label material is not
transported at all
Transport rollers are not driven
Manufacturer Service
Transfer ribbon is not
transported at all
Transfer ribbon torn
Insert transfer ribbon anew and
depress Print-Key
Unauthorized Paper Jam- /
Paper End-Error Message
Paper Sensor set incorrectly
Execute the option
Start?
in menu
Printer Data/Automat. Paper Sensor
In dispensing mode the label is
retracted before it can be
taken out
Paper Jam
Bring label into dispensing position
by using the -key and remove it
(remove Dispensing Table if
necessary )
Every error switches the display from the standard window to the error window, and activates the error-LED.
It is also possible that several errors occur at the same time, for example sequence errors, where the error
with the highest priority is displayed. The priority increases with the increasing error code number.
Inside the status display up to 8 error codes will be displayed in the 2nd status window
(depress status-key 2x).
The error-messages as displayed in the LCD-display are divided into 3 categories:
Error Codes:
01 - 99
-
WARNING
lowest priority
100 - 239
-
ERROR
240 - 255
-
HARDWARE
highest priority
