PATHWAY HD Code Compliant Modular Access System Installation Manual
Page 28 of 92
4.4.
RAMP HANDRAILS
4.4.1.
Ramp handrails are specific to the ramp length and provided in pairs when ordered
with the ramp. The procedure for attaching ramp handrails is the same for two-line
rails and picketed guards.
Regardless of handrail/guard styles, assemble handrail/guard bolts loosely (do
not fully tighten) until all handrails/guards have been installed on the ramps
and or platforms.
4.4.2.
One ramp handrail is required on each side of the ramp (handrails of the same
length are interchangeable side-to-side).
4.4.3.
In multiple ramp runs, handrail connectors (included in the CONNECTOR – RAMP
TO RAMP) are used to join handrails together.
4.4.4.
Refer to FIGs. 4.5 through 4.7 for the following steps:
4.4.4.1.
Install an adjustable handrail bracket bottom (included with ramp
handrail hardware) in the upper holes of the frames facing the ramp
walking surface (FIG. 4.5). Use the supplied 5/16”-18 x 2-1/4” socket
head cap screws, 5/16”-18 nylon insert locknuts and 5/16” flat washers
oriented as shown.
4.4.4.2.
Tighten the
5/16″ nuts just enough to hold
the adjustable handrail
bracket bottoms in in line with the frame posts but still allow the
bracket to pivot.
4.4.4.3.
If a lower (child) handrail (purchased separately) is being used, install
adjustable handrail bracket bottoms in the lower holes in the same
manner.
FIG. 4.5
