CAUTION:
Always use a power supply supplied or specified by extron for use with
the TLP 350CV. Use of an unauthorized power supply voids all regulatory
compliance certification and may cause damage to the supply and the
TLP 350CV.
Unless otherwise stated, the AC/DC adapters are not suitable for use in
air handling spaces or in wall cavities. The power supply is to be located
within the same vicinity as the extron A/V processing equipment in an
ordinary location, Pollution Degree 2, secured to the equipment rack
within the dedicated closet, podium or desk.
The installation must always be in accordance with applicable provisions
of National electrical Code ANSI/NFPA 70, article 75 and the Canadian
electrical Code part 1, section 16. The power supply shall not be
permanently fixed to building structure or similar structure.
Mounting the Power Supply (US models only)
Under Desk Mount
Release
Bracket
Wood screws
(Included)
The ZipClip 100 mounting kit, included with the
TLP 350CV, enables the power supply to be securely
mounted on most surfaces, including racks, tables,
and lecterns.
Attach the bracket to the mounting surface using
two or more screws, as shown. Make sure the clip
is oriented with the appropriate surface facing the
mounting surface and with the tab accessible from
the front of the furniture.
Using tie wraps for cable strain relief
1.
Attach the power supply to the ZipClip 100
mounting clip.
2.
Fasten the power output cord to the
ZipClip base.
a.
Insert tie wraps along the notches
on the side of the power supply and
through the ZipClip tie wrap anchor
points, then around the cord.
b.
Pull the tie wrap until secure. Do not
over tighten.
Cable
Strain
Relief
TLP 350CV • Connect the TLP 350CV
11