Extron electronics SMD 101, User Manual

Page: 38 / 162

To load a stream:
1. Click the Player tab in the upper left of the SMD 101 embedded web page (see figure
29 ,
1
on page 30).
2. Click the Streams tab (
2
) in the browser panel.
3. Click the + button adjacent to one or more folders (
3
) to expand the desired folders, or
click the button (
4
) within the Streams tab to expand all the folders.
4. If desired, click on the filters at the bottom of the panel (
5
) and select an option from
the drop-down list to narrow the list of sources based on the following factors (see
Filter , below).
5. Click the stream name in the list to select it (
6
).
You can do the following with a selected stream:
• Load the stream. Click Load at the bottom of the Streams tab.
• Right-click on a stream and select one of the options from the pop-up menu to:
•
Load the stream for playback
• Add it to a playlist (see Playlist Editor on page 41)
• Get information about the stream
• Set it as the default boot play source (see
Boot Play
on page 61)
• Set it as the stream to play in case of failover (see Fail Over on page 62)
• Click and drag the stream anywhere on the Player Controls panel to load it (see
Player Controls Features on page 23).
• Click and drag the stream into the Source field in the Player Controls panel.
•
Click and drag the stream into an available row in the Channels tab in the Lists panel
(see Lists on page 38) to create a new channel.
• Click and drag the stream into the Favorites tab in the Lists panel to save it to the
Favorites list for easy access at a later time (see Lists on page 38) .
• Click and drag the stream into an existing playlist in the Playlist Editor panel (see
Playlist Editor on page 41) to add it to a playlist.
Filter
Filters are provided to refine the list of streams viewed in the browser (see figure 29 ,
5
on
page 30). There are three filters with sub-filters to narrow the list of streams. The default
choice for each filter is
All .
• Source — Limits the browser to streams identified by their source device or location.
The drop-down list is populated with SAP source identification data. Limiting choices
are
All , Extron , or Other .
NOTE: A stream listed under
Extron
is defined as a member of the Extron group
by the SAP/SDP message. If the SAP/SDP message does not indicate Extron
group membership, it is listed in Other.
• Protocol — Limits the browser to streams identified by their transport protocol (UDP or
RTP). The list is dynamic, populated from SAP transport protocol data as the streams
are identified.
• Addressing — Limits the browser list to streams identified as unicast or as multicast.
NOTE:
Unicast streams can only be played if the connection (destination)
address is set correctly at the decoder.
Load
Loads a selected clip for playing (see figure 29 ,
7
).
SMD 101 • Web-based User Interface 31