MKP 3000 Remote Control Panel • Local Operation
MKP 3000 Remote Control Panel • Local Operation
Local Operation, cont’d
3-7
•
The most recently selected output is locked (unable
to be changed; assigned as the output to which the
entered input is tied unless a different output is
assigned [steps
2
and
3
]).
5
.
Turn the Select knob to scroll through the available inputs
until the LCD window shows your desired input number.
•
The LCD display shows the input that you selected
and its status (tied or untied).
•
The Take button blinks.
The Select knob scrolls only through those inputs that
are within the available range for this MKP or the
connected matrix switcher. See “Switcher Control
Settings section” in chapter 5, “HTML Operation,” for
information on authorizing inputs and outputs.
6
.
Press the Take button to confirm the tie.
The blinking Take button times out after 15 seconds if it
is not pressed.
If an optional MKP 10 MAAP keypad is connected, you
can use it in place of the Select knob to select a specific
input or output whose tied input you want to check. See
“MKP 10 MAAP Operation,” later in this chapter.
Deselecting a tie
To deselect (break) a tie,
1
.
Press the Input button.
2
.
Set the input to 0 by doing either of the following:
•
Turn the Select knob until No Signal is displayed in
the LCD window.
•
If an MKP 10 MAAP is installed in your MKP, press 0
on its keypad.
The Take button begins to blink.
3
.
Press the Output button.
4
.
Select the output that you want to untie by doing either of
the following:
•
Turn the Select knob until the desired output number
is displayed in the LCD window.
•
On the MKP 10 MAAP keypad, press the desired
output number.
5
.
Press Take.
When an input or output outside the available range for
this MKP or the connected matrix switcher is selected
using an optional MKP 10 MAAP keypad, the LCD
display shows
Invalid Input
or
Invalid Output
.
6
.
Press the Take button to confirm the tie.
The blinking Take button times out after 15 seconds if
not selected.
Creating a tie in input-only mode
In input-only mode, you select an output to which you can tie
only one input. To create a tie in input-only mode,
1
.
Select the type of tie (audio only, video only, or audio and
video) by repeatedly pressing the I/O button until it lights
in the desired color:
•
Video only
selected
— The I/O button lights green.
•
Audio only
selected
— The I/O button lights red.
•
Video and audio selected
— The I/O button lights
amber.
2
.
Press the Output button to specify that the next number
that is entered will be an output number.
•
The Output button lights amber.
•
If it was lit, the Input button turns off.
3
.
Turn the Select knob to scroll through the available
outputs until the LCD window displays the desired output
number.
As you scroll through the outputs, the LCD display
indicates whether or not the output is tied.
The Select knob scrolls through only those outputs that
are within the available range for this MKP or the
connected matrix switcher. See “Switcher Control
Settings section” in chapter 5, “HTML Operation,” for
information on authorizing inputs and outputs.
The LCD display shows the output that you selected and
its status (tied or untied).
4
.
Press the Input button to specify that the next number
entered will be an input number.
•
The Input button lights amber.
•
If it was lit, the Output button turns off.
3-6
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203