Sending an e-mail alert through Telnet
To complete the process of sending an e-mail alert, you must send it through a Telnet
session and receive confirmation. To do so:
1.
Open a Telnet session (see
on how to do this).
2.
Use the
Send e-mail
SIS command to send the alert to the e-mail address of
a numeric mailbox (see
on the previous page). See
Response Table for SIS Commands
on page 27 for specific command code.
For example, the code for sending an alert from the 4th numeric mailbox would be
Esc
4
SM
}
See the
Global Configurator Help
File
for detailed information on monitoring and scheduling.
Upgrading the firmware
Firmware upgrades become available as improvements are made to the versatility and
functionality of the IPL T CR48. These upgrades are available for download from
.
ATTENTION:
•
Valid firmware files must have the file extension .S19. A file with any other extension
is not a firmware upgrade for this device and could cause the device to stop
functioning
•
Les fichiers firmware valides doivent contenir l’extension fichier .S19. Un fichier
avec n’importe quelle autre extension n’est pas une mise à jour de firmware pour
cet appareil et l’appareil pourrait arrêter de fonctionner.
To upgrade the firmware:
1.
Click
Firmware
Upgrade
on the menu (on the left side of the window). The
Firmware
Upgrade
page (figure 18) is displayed.
Figure 18.
Firmware Upgrade Page
2.
Click
Browse
to find the most current available version of the firmware that has been
downloaded on your PC.
3.
If you find a later version than the one shown above the box, click
Upload
to upgrade
to the newer version.
ATTENTION:
•
Do not interrupt the firmware upload before it is 100% complete. Interrupting
the upload corrupts the firmware and the switcher will not operate properly
afterwards.
•
N’interrompez pas le chargement du firmware avant qu’il ne soit entièrement
terminé. L’interruption du chargement altère le firmware et empêche le
sélecteur de fonctionner correctement.
18
IPL T CR48 • Communication and Control
21
