IPL T CR48 Reset Mode Summary
Mode Activation
Result
Purpose and Notes
Reset All IP Settings
4
Hold down the
Reset
button
for about 6 seconds until the
Power LED blinks twice (once at
3 seconds, again at 6 seconds).
Then, release and press
Reset
momentarily (for <1 second)
within 1 second*.
Mode 4:
•
Enables ARP capability.
•
Sets the IP address back to
factory default:
192.168.254.254
•
Sets the subnet back to
factory default.
•
Sets the default gateway.
address to the factory default.
•
Sets port mapping back to
factory default.
•
Turns DHCP off.
•
Turns events off.
Mode 4 enables you to set IP
address information using ARP
and the MAC address.
Reset to Factory Defaults
5
Hold down the
Reset
button for
about 9 seconds until the Power
LED blinks three times (once at
3 seconds, again at
6 seconds, again at 9 seconds).
Then, release and press
Reset
momentarily (for <1 second)
within 1 second*.
Mode 5 performs a complete
reset to factory defaults
(except the firmware).
•
Does everything mode 4
does.
•
Clears driver-port associations
and port configurations.
•
Removes button or
touchpanel configurations.
•
Resets all IP options.
•
Removes scheduling settings.
•
Removes all files from the
IPL T CR48.
Mode 5 is useful if you want to
start over with configuration and
uploading, and also to replace
events.
This reset, equivalent to the
E
ZQQQ
}
SIS command,
also removes the initial serial
number password and sets it
to no password (see
on page 19 to change a
password).
*For modes 3, 4, and 5, nothing happens if the momentary press does not occur within 1 second.
IPL T CR48 • Installation and Operation
10
