Extricom EXRE-10, User Manual

Page: 45 / 74

Field Description
WEP Keys The WEP Keys area is only enabled if the cipher selected in the
Choose Method field is WEP or WEP104. In the WEP Keys area,
you define the WEP Key that is used for encrypting or decrypting.
You can define all four WEP keys. For each key you define, select
the input format (ASCII or HEX) and enter the key according to
the following table:
Cipher ASCII HEX
WEP64
(or WEP64+802.1x)
5 characters 10 digits
WEP128
(or 802.1x) 13
characters 26 digits
Transmission Key Select the WEP64/WEP128 key to be used for transmitting the
data from the AP.
WPA
The WPA area is only enabled if the cipher selected in the Choose
Method field is WPA/WPA2 TKIP/AES.
WPA-PSK If WPA/WPA2 with Pre-Shared key authentication is used, the
WPA-PSK field is enabled. In this case, select one of the
following input formats, and enter the corresponding key listed:
z
For ASCII, enter 8-63 characters.
z
For HEX, enter 64 digits.
WPA/RADIUS
Re-key Interval Enter the amount of time (in seconds) that elapses before the
Group Key is changed.
RADIUS Define the RADIUS servers parameters if:
z
The cipher is WEP64/WEP128, and the 802.1x authentication
method is selected.
z
The cipher is TKIP/AES, and the WPA/WPA2 (RADIUS)
authentication method is selected.
Server Address Enter the address of the RADIUS server.
"
Use Server # 1 if only one server is used. Use
consecutive servers if several servers are used.
Server Port Enter the RADIUS server port.
Server Password Enter the RADIUS server password.
Enter the time which the Extricom switch waits for the RADIUS
server response. Server Timeout
The Extricom WLAN System User Guide 37